Trust Start-Line ACM-2000 Mode D'emploi page 6

EN
ACM-2000 BUILD-IN SWITCH
1. Switch off the mains voltage
2. Remove the existing lighting
Detach the existing lighting and disconnect the wires. Do not exceed the maximum load: 2000W.
3. Connect the live and neutral wire
Connect the live wire to the outer left [L] terminal. Connect the neutral wire to the outer right [N]
terminal. Tighten the clamping screws.
4. Connect the switch wire and neutral wire to the lamp
Connect the (black) switch wire from the lamp to the [ L L ] socket.
Connect the (blue) neutral wire from the lamp to the left [N] contact.
5. Switch on the mains power (electric meter box) to continue the installation
Shock hazard! Do not contact any exposed wiring. Only touch the plastic housing of this product.
6. Activate learn-mode
Press the learn-button on the receiver for 1 second. The learn-mode will be active for 12 seconds and
the LED-indicator will blink slowly.
7. Assign Trust Smart Home transmitter code
While the learn-mode is active, send an ON-signal with any Trust Smart Home transmitter to assign
the code to the receiver's memory.
8. Code confirmation
The LED will flash fast to confirm the code has been received. The receiver can store up to 32 different
transmitter codes in its memory. The memory will be preserved when the receiver is moved to
another location or in case of power failure.
6