Horizon Fitness CE8.8 Manuel Du Propriétaire page 7

ASSEMBLY STEP 3
G
H
I
4 3
12
HZ14_OM_NA_CE8.8_Rev1_2.indd 12-13
HARDWARE FOR STEP 3
PART TYPE
G SOCKET CAP BOLT
H SPRING WASHER
I FLAT WASHER
Open HARDWARE FOR STEP 3.
A
Align GUIDE RAIL SET (4) with MAIN
B
FRAME (2) as shown.
Lift up on the MANUAL INCLINE LIFT
C
LEVER (3) and place it in one of the holes
inside the MAIN FRAME (2).
Attach the GUIDE RAIL SET (4) to the
D
MAIN FRAME (2) using 4 BOLTS (G),
4 SPRING WASHERS (H) and 4 FLAT
WASHERS (I).
2
ASSEMBLY STEP 4
QTY
4
4
4
5
7
NOTE: Be
careful not
2
to pinch any
wires while
attaching the
console mast.
HARDWARE FOR STEP 4
PART TYPE
J WAVY WASHER
K FLAT WASHER
B SPRING WASHER
L BUTTON HEAD BOLT
6
Open HARDWARE FOR STEP 4.
A
Carefully pull the CONSOLE CABLE (5)
8 B
J
through the CONSOLE MAST (6) using
B
the twist tie located inside the CONSOLE
MAST (6).
Attach CONSOLE MAST (6) to MAIN
C
FRAME (2) using PRE-INSTALLED
K L BOLTS AND WASHERS (7).
Slide WAVY WASHER (J) over CRANK
D
(8) followed by PEDAL ARM (9) as shown.
9
Rest pedal arm wheel on guide rail.
Attach the PEDAL ARM (9) to the CRANK
E
(8) using 1 FLAT WASHER (K), 1 SPRING
WASHER (B) and 1 BOLT (L).
Repeat steps D–E on the opposite side of
F
the elliptical.
QTY
2
2
2
2
13
6/4/14 8:59 AM