Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
struction guide performed by a
professional. Only use original
parts. Allow the device to cool
off before any maintenance or
cleaning is undertaken. There is
a risk of burning!
Always check the device before using it
for obvious deficiencies such as loose,
worn or damaged parts, correct the posi-
tioning of screws or other parts. Examine
the grinding disc in particular. Exchange
the damaged parts.
Cleaning
Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
•
Thoroughly clean the device after
every use.
•
Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
Servicing
Replacing carbon brushes
Switch off the appliance and dis-
connect the power supply. Let the
appliance cool down.
1. Loosen the screw (
tenance cover (
2. Remove the maintenance cover
(
6).
3. Lift the compression spring (17) out of
the groove for the spring (19) the car-
bon brush (18).
4. Pull the contact shoe (22) from the
contact plug (21).
38
All manuals and user guides at all-guides.com
5) of the main-
6).
5. Pull out the brush (18) from the guide.
6. Insert a new carbon brush (18) into the
guide.
7. Place the connector (20) in a bow in
the groove for the compression spring
(19) past. Lead the connector (20)
through the side opening of the leader-
ship.
8. Push the contact shoe (22) on to the
contact plug (21).
9. Replace the compression spring (17)
on the nut of the compression spring
(19) the carbon brush (18).
10. Reattach the screw (
nance cover (
11. Repeat the procedure 1 to 10 on the
other side of the unit. The carbon
brushes are always in pairs to share.
Storage
•
Store the appliance in a dry place well
out of reach of children.
•
Grinding discs must be dry and stored
upright and should never be stacked.
Waste disposal and
environmental protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Electrical machines do not belong
with domestic waste.
•
Hand over the device at an utilization
location. The plastic and metal parts
employed can be separated out and
thus recycled use can be implement-
ed. Ask our Service-Center for details.
•
Defective units returned to us will be
disposed of for free.
5) the mainte-
6)
Publicité
Table des Matières
