Installing/Changing The Wire Brush - Deltafox DP-EAG 1225 Traduction De La Notice D'utilisation Originale

GB
spindle flange in a fixed position. Pull
the clamping nut (15) tight again using
the chuck key (12).
You can let go of the spindle lock but-
ton (1).
Installing/changing the wire
brush
1. Press the spindle stop button (1).
2. Turn the mounting spindle (16) un-
til the spindle stop button holds the
mounting spindle in a fixed position.
Keep the spindle stop button (1) de-
pressed.
3. Release the wire brush with a com-
bination wrench (not included in the
scope of delivery). You can now re-
lease the spindle stop button (1).
4. Place the desired wire brush onto the
mounting spindle.
5. Press the spindle stop button (1) and
rotate the wire brush on the mounting
spindle (16). Tighten the wire brush
using a combination wrench. You can
now release the spindle stop button
(1).
Turning the grip surface
The rear grip surface can be turned 90° in
both directions.
1. Press the release (4b) on the grip sur-
face.
2. Turn the grip surface in the desired
direction. The grip surface snaps into
place. Only 3 levels can be set (-90°,
0° and 90°).
Operation
Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
36
All manuals and user guides at all-guides.com
- Only use grinding discs and
accessories recommended by
the manufacturer. Using other
attachment tools and other ac-
cessories can represent a risk
of injury for you.
- Only use accessory parts which
bear information about the
manufacturer, type of connec-
tion, dimension and permitted
number of revolutions.
- Only use accessory parts where
the printed rotational speed is at
least as high as what has been
specified on the name plate of
the device.
- Do not use any broken,
cracked, or otherwise damaged
grinding discs.
- Never operate the device with-
out protective equipment.
- Support the plates or work-
pieces in order to reduce
the risk of kickback from a
jammed cutting disc. Large
workpieces may bend under
their own weight. The workpiece
must be supported on both
sides of the disc, not only near
the cutting disc, but also at the
edge.
Keep your hands away from the
disc when the device is in op-
eration. Risk of injury.
Information on replacement:
• Never operate the device with-
out protective equipment.
• Ensure that the rotation speed
stated on the tool is the same
or higher than the nominal idle
speed of the device.