Replacing The Remote Control Battery - Bose WAVE RADIO II Notice D'utilisation

Cleaning

Replacing the remote control battery

All manuals and user guides at all-guides.com
Use only a soft dry cloth to clean the enclosure of your Wave
use a soft-bristled attachment to gently vacuum the front of the enclosure. Do not use any
liquid cleaning solutiuons, solvents, chemicals, alcohol, ammonia or abrasives.
CAUTION: Do not allow liquids to spill into any openings in the enclosure. If liquids get into the
unit, turn it off immediately. Call Bose
service. See the list of phone numbers inside the back cover.
WARNING: Keep the remote control battery away from children. It may cause a fire or chemical
burn if mishandled. Do not recharge, disassemble, heat above 212ºF (100ºC) or incinerate.
Dispose of a used battery promptly. Replace only with a battery of the correct type and model
number.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with Duracell,
Eveready, Energizer, Maxell, Toshiba or Shun Wo CR2032 or DL2032, 3-volt Lithium battery.
To replace the remote battery:
1. Place the remote face down on a flat surface.
2. Using your finger, push the tab lock to the side as shown and hold. Slide the battery
compartment open.
3. Remove the old battery and install the new one with the plus (+) symbol facing up.
4. Gently slide the battery compartment closed. It locks automatically.
Maintaining Your Wave
®
®
Customer Support as soon as possible to arrange for
® radio II
radio II. If necessary, you may
23