Bose WAVE RADIO II Notice D'utilisation page 21

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Setting the room code
Alarm
Time
Menu
Tune
Alarm
Time
Menu
Enabling the low-power mode
Alarm
Time
Menu
Tune
Alarm
Time
Menu
All manuals and user guides at all-guides.com
radio II comes from the factory ready to operate as a second room (room code B)
Your Wave
®
when connected to a Bose
radio II with your Lifestyle
®
code to match that of the remote control you are using for that room.
Refer to your Lifestyle
®
system operating guide for more information on room codes.
1. Press and hold Alarm Time (Menu) until -SETUP MENU- is displayed.
>
2. Press Tune
seven times until ROOM- B
the room letter indicate how the microswitches should be set on the Lifestyle
control. See your Lifestyle
3. Press Time – or Time + to select a room code other than room B.
4. Press Alarm Time (Menu) to exit the set-up menu or wait 10 seconds for the set-up
menu to end automatically.
radio II has a low-power mode which causes the system to use less energy after
®
Your Wave
you turn it off. If the low-power mode is enabled, the display automatically turns off after 30
minutes. Just before the display goes blank, LOW POWER- ON is displayed.
In the low-power mode, the clock still runs normally, presets are maintained and if an alarm is
set, the system turns on at the programmed alarm time. While in the low-power mode,
pressing FM, AM, AUX or Preset 1 to 6 turns the system ON in the normal way. Pressing any
other remote key, or one that does not turn the system on, lights up the display for another 30
minutes and then turns it off again.
1. Press and hold Alarm Time (Menu) until -SETUP MENU- is displayed.
>
2. Press Tune
eight times until LOW POWER- OFF is displayed.
3. Press Time – or Time + to change LOW POWER- OFF to LOW POWER- ON.
4. Press Alarm Time (Menu) to exit the set-up menu or wait 10 seconds for the
set-up menu to end automatically.
Personalising Your Wave
®
link enabled Lifestyle
®
system. If you want to use your Wave
system beyond a second room you will need to change the room
®
system operating guide for details.
®
radio II
is displayed. The dashes following
®
®
remote
21

Publicité

Table des Matières
loading

Table des Matières