Functional Description; Intended Use - Bosch GKS 160 Professional Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-185-004.book Page 21 Monday, February 8, 2010 3:41 PM
Adjust the riving knife as described in this
instruction manual. Incorrect spacing, posi-
tioning and alignment can make the riving
knife ineffective in preventing kickback.
Always use the riving knife except when
plunge cutting. Riving knife must be re-
placed after plunge cutting. Riving knife
causes interference during plunge cutting
and can create kickback.
For the riving knife to work, it must be en-
gaged in the workpiece. The riving knife is
ineffective in preventing kickback during
short cuts.
Do not operate the saw if riving knife is
bent. Even a light interference can slow the
closing rate of a guard.
Do not reach into the saw dust ejector with
your hands. They could be injured by rotat-
ing parts.
Do not work overhead with the saw. In this
manner you do not have sufficient control
over the power tool.
Use suitable detectors to determine if utili-
ty lines are hidden in the work area or call
the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
Do not operate the power tool stationary. It
is not designed for operation with a saw ta-
ble.
Do not use high speed steel (HSS) saw
blades. Such saw blades can easily break.
Do not saw ferrous metals. Red hot chips
can ignite the dust extraction.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Bosch Power Tools
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

The machine is intended for lengthways and
crossways cutting of wood with straight cutting
lines as well as mitre cuts in wood while resting
firmly on the workpiece. With suitable saw
blades, thin-walled non-ferrous metals, e. g.,
profiles, can also be sawed.
Working ferrous metals is not permitted.
1 609 929 W40 | (8.2.10)
English | 21