GRAUPNER GM-Racing 90162.RTR Monster Truck MT6 Fuel 2WD Manuel D'utilisation page 9

• In order to adjust the high-speed revolutions, raise the vehicle at the rear wheels and give full throttle for
a short time. If the engine accelerates retarded without smoke development, then it runs too lean. In this
case you turn the high-speed needle slightly against the clockwise direction (approx.1/8 revolution). If the
engine accelerates slowly with heavy smoke development, it is too rich, then close the high-speed needle
in the clockwise direction for approx. 1/8 revolution.
• Caution: Rev up the engine without load only for a few seconds, otherwise you may destroy the engine!
Usually after adjustuíng the low- and high-speed needle you have to re-adjust the idle adjustment screw
for correct idling!
Fig. 1
SERVICE
In addition to the already described service work should always try your vehicle in order to keep fi ring to pre-
vent wear. If dirt in moving parts, they can this is the performance of the model signifi cantly affect. Remove
dirt or dust with compressed air, a soft brush and / or with a toothbrush. If possible, try using no solvents, as
this is in fact the dirt in the camps and in the normally inaccessible places and thus cause additional wear.
We recommend the following simple procedures:
• Remove dirt and dust as far as possible with the methods described above.
• Keep the fuel never longer than two hours in the tank.
• After 1-2 hours runtime it is necessary to clean the air fi lter.
• Check the car on worn, broken or gripping parts and repair them if necessary.
• Check regularly the fi xed seating all screws and tighten them if necessary.
SPECIFICATIONS
Lenght:
Width:
Height:
Tyre Diameter:
Weight:
Fuel Tank Capacity: 700 cm
Gear Ratio:
Engine:
Radio System:
GM-Racing 90162.RTR Monster Truck MT6 Fuel 2WD
All manuals and user guides at all-guides.com
Fig. 2
820 mm
400 mm
530 mm
210x110 mm
ca. 13.8 g
3
13.3 : 1
30 cm 3 with pull starter
GM-Racing XG-6i Sport Spec
08