Technical Specifications; Replacement Parts And Wearing Parts - Beurer IH 18 Mode D'emploi

11. Technical specifications

Model
IH 18
Type
IH18/1
Dimensions 160 x 155 x 84 mm
(WxHxD)
Weight 1.3 kg
Operating approx. 0.8-1.45 bar
pressure
Atomiser fill min. 2 ml
volume max. 8 ml
Medicine flow ca. 0.4 ml/min.
Sound pressure approx. 52 dBA
(acc. to DIN EN 13544-1 section 26)
Mains 230 V~, 50 Hz; 230 VA
connection UK: 240 V~; 50 Hz; 240 VA
Expected service 1000 h
life
Operating Temperature: +10 °C – +40 °C
conditions Relative humidity: 10% – 95%
Storage and Temperature: 0 °C – +60 °C
transport Relative humidity: 10% – 95%
conditions Atmospheric pressure: 500 hPa –
1060 hPa
Aerosol Flow: 5.31 l/min
Properties Aerosol delivery: 0.171 ml
Aerosol delivery rate: 0.082 ml/min
Particle size (MMAD): 3.16 µm
Subject to technical modifications.
Particle size diagram
Measurements were performed using a sodium
fluoride solution with a "Next Generation Impac-
tor" (NGI).
This diagram may not be applicable for suspensions
or highly viscous medicines. More information can be
obtained from the relevant medicine manufacturer.
Note
If the unit is used outside of the specifications, proper
function is no longer guaranteed!
All manuals and user guides at all-guides.com
We reserve the right to make technical changes to im-
prove and further develop the product.
This device and its accessories comply with European
standards EN60601-1 and EN60601-1-2, as well as
EN13544-1, and is subject to special safety measures
in terms of electromagnetic tolerance. Note that port-
able and mobile RF communication equipment can
affect this unit. More details can be requested from
the stated Customer Service address or found at the
end of the instructions for use. The unit conforms to
the requirements of the European Directive for Medical
Products 93/42/EC, the MPG (German Medical units
Act).
ELECTROMAGNETIC COMPATIBILITY
• The device complies with current specifications with
regard to electromagnetic compatibility and is suit-
able for use in all premises, including those des-
ignated for private residential purposes. The radio
frequency emissions of the device are extremely low
and in all probability do not cause any interference
with other devices in the proximity.
• It is recommended that you do not place the device
on top of or close to other devices. Should you notice
any interference with other electrical devices, move
the unit or connect it to a different socket.
• Radio equipment may affect the operation of this
device.
12. Replacement parts and wea-
ring parts
Replacement parts and wearing parts are available
from the corresponding listed service address under
the stated material number.
Designation
Nebulisation stopper
Yearpack (contains Mouth-
piece, Adult mask, Child
mask, Atomiser, Compressed
air hose, Filter)
18
Material REF
PP 162.819
PP/ PVC 601.21