ECOVACS DEEBOT 6 Serie Mode D'emploi page 11

All manuals and user guides at all-guides.com
4 Charge DEEBOT6
Place DEEBOT6 on the Charging Dock
making sure the Charging Contacts on
DEEBOT6 and the Charging Dock Pins make
a connection.
Charge DEEBOT6 for at least 12 hours
before the first use.
The Status Light Indicators on the top of the robot and the Battery Display on the robot's
*
Control Panel Screen blink when DEEBOT6 is charging and go off when DEEBOT6 is fully
charged.
*
Remove DEEBOT6's battery if the robot will not be used for a long time. In case of battery
leakage, please remove the battery and wipe the battery slot clean while wearing protective
gloves.
*
If battery is fully discharged or not used for a long time, its capacity may decrease and need
to be reactivated.
*
To reactivating the battery: Place the robot on the Charging Dock by hand, remove after
charging for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
*
DEEBOT6 uses a long life Ni-MH battery, and does not require frequent replacement. To
replace the battery, contact Customer Service or follow the below instructions:
a. Unscrew the Battery Cover Screws, remove Battery Cover.
b. Remove the battery and disconnect the fasteners.
c. Connect the corresponding positive and negative fasteners on the new battery. Insert
the new battery, reassemble the Battery Cover and screw in the Battery Cover Screws.
Start
5
Press the AUTO Mode Button on the robot
or on the Remote Control.DEEBOT6 starts to
work immediately in AUTO Cleaning Mode.
To choose another Cleaning Mode,
*
please refer to section 3.3 Cleaning Mode
Selection for details.
Pause
6
Pause DEEBOT6 by pressing any button on DEEBOT6 or the Pause Button on the Remote
Control.
DEEBOT6 can be directed to move forward, backward, left and right using the Direction
*
Control Buttons on the Remote Control when it is paused. DEEBOT6 does not clean when
Paused.
3. Operating and Programming
9
EN