Complete Installation; Install Filters; Check Operation - IKEA W10177447B Instructions D'installation Et Guide D'utilisation Et D'entretien

Complete Installation

1. Install vent cover.
Push lower cover down onto hood and lift upper cover to
ceiling and install with two 2.9 x 9.5 mm screws.
Connect the upper and lower vent covers with
two 3.5 x 9.5 mm screws apiece from the inside of the hood.
E
C
A. Upper vent cover
B. Lower vent cover
C. 2.9 x 9.5 mm screws
D. 3.5 x 9.5 mm screws
E. Bracket

Install Filters

1. For non-vented (recirculating) installations, install charcoal
filter over grille on blower housing and align the pins (B) on
the cowl with the slots (C), then turn the filter clockwise until it
locks in place. Repeat with other charcoal filter.
A
B
A. Blower housing
B. Pins
C. Slots
2. For all installations, insert back edge or metal filter into rear
channel of the filter opening.
3. Push handle toward the rear and push filter up.
All manuals and user guides at all-guides.com
C
A
B
D
B
C
4. Pull filter toward the front and insert into front channel.
Install the Front Panel
5. Align the pins on the range hood with the lock springs on the
front panel.
6. Press the front panel firmly into place.
A
7. Check to ensure that the front panel is locked into place.
1. Press the "A" button to turn the light on or off.
2. Press the "C" button once. The blower should turn on at low
C
speed. Press twice for medium speed and three times for
high speed.
3. Press and hold the "C" button for more than 2 seconds to
turn off the blower.
4. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
5. Disconnect power supply.
6. Check that the wiring is correct.
7. Replace all parts and panels before operating.
8. Reconnect power.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
A
B
A. Pins
B. Front panel

Check Operation

1 2 3
B
A
A. Light button
B. Indicator lights
C. Speed button
C
11