Installation Modes - IKEA SVAVANDE Mode D'emploi

ENGLISH
Use
• Switch off or unplug the appliance
from the mains supply before
carrying out any maintenance work.
• The top of the hood must not to be
used as a shelf.
• The extractor hood has been
designed exclusively for domestic
use to eliminate kitchen smells.
• Never use the hood for purposes
other than for which it has been
designed.
• Never leave high naked flames
under the hood when it is in
operation.
• Adjust the flame intensity to direct
it onto the bottom of the pan only,
making sure that it does not engulf
the sides.
min 471 mm
Deep fat fryers must be continuously
max 861 mm
monitored during use: overheated oil
can burst into flames.

Installation modes

The hood has been designed to be
installed and used either as a "Exhaust
mode", or as a "Recirculation mode".
Exhaust mode (see symbol
in installation booklet)
min 471 mm
min 471 mm min 569 mm
Cooking steam is sucked and
max 861 mm
max 861 mm
max 861 mm
channelled outside the house through
a discharge duct (not supplied), fitted
to the hood steam outlet.
Ensure that the discharge duct is
correctly fitted to the air outlet, unit
using an appropriate connection
system.
Recirculation mode (see
symbol in installation booklet)
min 569 mm
max 861 mm
min 569 mm The air is filtered through one or more
max 861 mm
the charcoal filters, and then resent
into room.
Important: Ensure appropriate air
circulation around the hood.
Important: If the hood is supplied
without charcoal filters and installed
on recirculation mode, these must be
fitted before the hood can be used.
Filters are available in shops.
The hood should be installed away
from particularly dirty areas, windows,
doors and heat sources.
The accessories for wall fixing are
not included because wall made of
different materials require different
types of fixing accessories. Use fixing
systems suitable for the walls of your
home and the weight of the appliance.
For more details, contact a specialized
dealer.
Keep this booklet for future
consultation.
Filter Alarm
The Alarm for grease filter is Active
on the Hood as default, for the Reset
check control panel.
The Alarm for long life charcoal filter
can be Actived as per procedure on
Control Panel.
When the filter alarm is activated, the
following messages will appear over
time:
Grease filter alarm must be cleaned:
"A" key flashes once per second. For
maintenance see paragraph Care and
cleaning.
Long Life charcoal filter alarm must
be cleaned: "A" key flashes twice
per second. For maintenance see
paragraph Care and cleaning.
Once the filters have been regenerated
reset the alarm signal (see paragraph
Control Panel).
9
7