Remote Control - Monacor International PA-803DMP Mode D'emploi

SD/MMC
MIC 1 MIC 2/LINE 1
0 10
4 Operation
1) Before first-time operation, make sure that the
initial volume is not too high: Set the control
MASTER for the total volume approximately to
230 V~
50 Hz
the position "9 o'clock" . Then switch on the
amplifier with the switch POWER . The green
FUSE
power LED ON will light up .
USE ONLY WITH A 250V FUSE
2) Use the controls MIC..., LINE... and TEL to
24 V
mix the signal sources or to fade them in or
COM
out . Set the controls of the inputs which are
not used to "0" .
3) Adjust the total volume with the control MAS-
TER . The LEDs "-30, -10, 0dB, CLIP" will indi-
cate the output level . To prevent distortions,
only turn up the control MASTER to such a
level that the red LED "CLIP" will not light up .
4) Use the controls BASS and TREBLE to adjust
the sound .
5) If the LED "PROT" lights up, the amplifier is
overheated or overloaded or has a short circuit
at one of the speaker outputs . In this case,
switch off the amplifier and have the fault
eliminated .

4.1 Remote control

The remote control for the music module is sup-
plied with a battery . Before operating the remote
control for the first time, remove the protective
film from the battery holder . When pressing a
button on the remote control, always point the
remote control at the amplifier . Make sure that
there are no obstacles between the amplifier and
the remote control .
If the remote control is not used for a longer
period of time, remove the battery as a precau-
tion . It may leak and damage the remote control .
10
All manuals and user guides at all-guides.com
USB
SD MP3
VOL− SCAN VOL+ MODE
MIC 3/LINE 2 LINE 3
0 10 0 10 0 10
ANTENNA
SPEAKER OUTPUT
4 Ω 8 Ω 16 Ω 70 V 100 V
LINE 4 TEL
0 10 0 10
FM
1 ON - LINE 1 3 ON - PH.PWR ON
OFF - MIC 2 OFF - PH.PWR OFF
TEL INPUT MOH OUTPUT
2 ON - LINE 2 4 ON - PRIO. TEL
600 Ω/100 mV 600 Ω/1 V
OFF - MIC 3 OFF - PRIO. MIC 1
COM HOT COM HOT
MIC2/LINE1 MIC3/LINE2 SELECT
Replacing the battery
1) Push the latch of the battery holder to the
right (first arrow in the figure below) and re-
move the holder (second arrow) .
1.
2) Remove the old battery and insert the new
battery (3 V button cell, type CR 2025) into the
holder with the positive pole facing upwards .
3) Push the holder back into the remote control .
Never put discharged batteries in
the household waste . To protect the
environment, always take them to a
special waste disposal (e . g . collection
container at your retailer) .
ON
PROT
CLIP
0 dB
-10
-30
POWER
BASS TREBLE MASTER
–10 +10 –5 +5 0 10
dB dB
PWR STOP MUTE
MODE EQ
PREV NEXT
0
1 2 3
2 1
3
L
1 2 3 4
4 5 6
OFF
R
1 2 3 4
ON ON
MIC 1 LINE 3 LINE 4
7 8 9
2.
PA-803DMP
1
2
OUTPUT