Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
UDR-110
HANDHELD TRANSMITTER
MIC DESCRIPTION
MIC SETUP
-
First, push the unlock cover button
-
Unscrew the batteries cover.
-
Finally, pull out the batteries cover to reveal the LCD display.
To change the parameters, push the SET button until you you find the parameter you want to set.
-
Use Up & Down buttons to set the parameter and presse SET button to validate
-
To change frequency :
-
Press SET button, display shows CH001* ( channel number ) or 750.000* ( * frequency ) (* value depends of the current set ).
-
Use Up & Down buttons to select a channel or a frequency ( channel number from 1 to 99 ).
-
Display flashes.
-
Presse SET button to validate.
Note :
-
If you don't presse SET button after setup the parameter, the change will be not record.
-
Use the same frequency between transmitter and receiver
© Copyright LOTRONIC 2012
All manuals and user guides at all-guides.com
1)
POWER SWITCH
To switch the transmitter on, push ( and hold ) on this button during 2 or 3
seconds. The display lights on.
To switch the transmitter off, push ( and hold ) on this button during 2 or 3
seconds. The display lights off.
2)
BUILT-IN ANTENNA
3)
GRILL + CARTRIDGE
4)
BATTERIES COVER
Insert 2pcs AA 1.5V batteries. Respect the polarity.
5)
BATTERIES INDICATOR
If this led flashes, that means batteries level is low so you can replace them.
If the led stay on, that means the batteries are good.
6)
UP & DOWN BUTTONS
This two buttons are use to select the frequency. You can use this buttons to
set parameters of receiver too.
7)
SET BUTTON
After you select a frequency, push this button to validate your choice. Use to
validate the parameter setups too.
WWW.BSTDJ.COM
Page 13
Publicité
Table des Matières
