Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
UDR-110
DESCRIPTION OF RECEIVER
1)
HEADPHONE SOCKET
Connect your headphone on this socket to check the main signal of the receiver.
2)
POWER SWITCH
This switch is used to switch the receiver on or off..
3)
LEVEL CONTROL
Use this control to adjust the level of the outputs ( 10 & 11 ).
Note : If the level is too high, the sound will be saturated
Note : If you use the handheld transmitter too near from the speaker, you can hear a feedback effect which can destruct speaker
4)
LCD DISPLAY
The display shows you :
-
The current frequency
-
The frequency number
-
The RF level
-
The AF level
-
The current used antenna : I or II
-
The Mute indicator
-
The lock indicator
5)
LOCK INDICATOR
This indicator is light on when the lock function is enable. In this mode, you cannot change the frequency. This prevents inadvertent
operation problems
6)
FREQUENCY SELECTION BUTTONS
This two buttons are use to select the frequency. You can use this buttons to set parameters of receiver too.
Note : The receiver and the transmitter must to be the same frequency to get a good operating.
7)
FREQUENCY SET BUTTON
After you select a frequency, push this button to validate your choice. Use to validate the parameter setups too.
Use to enable the lock function.
8)
POWER SUPPLY SOCKET
Connect the external power supply provided with the set ( DC 13~15V )
Note : Don't connect an another kind of power supply on this socket ( AC or DC upper to 15V ) either you can destruct the receiver
9)
ANTENNA A SOCKET
Connect on this socket one of the two antenna provided with the set.
10) BALANCED OUTPUT
This output is the main output of the receiver. You must to connect it to an input of a mixer or directly to a power amplifier.
Note : This output is a balanced output. Use a XLR cable
11) UNBALANCED OUTPUT
This output is the main output of the receiver. You must to connect it to an input of a mixer or directly to a power amplifier.
Note : This output is an unbalanced output. Use a Jack 6.35mm cable
12) Sélecteur niveau volume
This selector is used to select the sensitivity level of the out put ( either mic (min), either line (max) ).
With this function, you can choose in which kind of input you want to connect the receiver ( either MIC, either LINE )
13) ANTENNA B SOCKET
Connect on this socket one of the two antenna provided with the set.
© Copyright LOTRONIC 2012
All manuals and user guides at all-guides.com
WWW.BSTDJ.COM
Page 10
Publicité
Table des Matières
