Proline PLC102 Notice D'utilisation page 15

All manuals and user guides at all-guides.com
Problem
There is too much frost
and ice
The lid doesn't close
completely
The lid is difficult to open
It is too warm in the
freezer
It is too cold inside the
freezer
The appliance does not
work at all. Neither cool-
ing nor lighting works
Possible cause
The temperature of the room
that contains the appliance is
too high for efficient operation
Products are not wrapped prop-
erly
The lid is not shut properly or do
not close tightly
The temperature is not set cor-
rectly.
There is excessive frost
The lid gaskets are dirty or sticky
Food packages are blocking the
lid
The lid gaskets are dirty or sticky
The valve is blocked
The temperature is not set cor-
rectly.
The lid does not close tightly or
it is not shut properly
Before freezing the appliance
was not precooled sufficiently
Large quantities of food to be
frozen were put in at the same
time
Food placed in the appliance
was too warm
Products to be frozen are
placed too closely to each other
The lid has been opened often
The lid has been opened for a
long time.
The temperature is not set cor-
rectly.
Plug is not connected to the
mains socket properly
Power does not reach the appli-
ance
The appliance is not switched
on
Solution
Try to reduce the temperature in
the room where the appliance
stands
Wrap the products better
Check if the lid closes well and
the gaskets are undamaged and
clean
Set a warmer temperature
Eliminate excess frost
Clean the lid gaskets
Arrange the packages in the right
way, see the sticker in the appli-
ance
Clean the lid gaskets
Check the valve
Set a lower temperature
Check if the lid closes well and
the gasket is undamaged and
clean
Pre-cool the appliance for enough
time
Wait some hours and then check
the temperature again. Next time
insert smaller quantities of food to
be frozen at any one time.
Allow food to cool to room tem-
perature before storing.
Place the products in a way so
that cold air could circulate
among them
Try to not open the lid often
Do not leave the lid open longer
than necessary
Set a warmer temperature
Connect the mains plug properly
Try connecting another electrical
device to the power outlet
Switch on the appliance
15