Maintenance And Storage; Sound Pressure Level; Sound Power Level; Vibration Level - Toro CCR 2000 Manuel De L'utilisateur

12. Never direct discharge toward or operate
snowthrower near glass enclosures, motor
vehicles, window wells or drop-offs.
13. Never direct discharge at bystanders or allow
anyone in front of the snowthrower.
14. Never clear snow off steep slopes or across the
face of slopes. Exercise extreme caution when
changing direction on slopes.
15. Do not overload the snowthrower by clearing
snow at too fast a rate.
16. After striking a foreign object or if snowthrower
vibrates abnormally, stop engine by turning key
to OFF. Thoroughly inspect snowthrower for any
damage, obstruction or loose parts. Repair
damage before restarting and operating.
17. WHENEVER YOU LEAVE THE OPERATING
POSITION, STOP ENGINE BY TURNING
KEY TO OFF. REMOVE KEY FROM
SWITCH IF UNIT WILL BE UNATTENDED.
18. Before inspecting, adjusting, repairing or
cleaning snowthrower, stop engine by turning
key to OFF. Always wait for all moving parts to
stop. Do not make adjustments while engine is
running.
19. After clearing snow, let engine run for a few
minutes so moving parts do not freeze.

Maintenance and Storage

20. REMOVE KEY FROM SWITCH when storing
snowthrower. Store key in a memorable place.
21. Never store snowthrower with fuel in fuel tank
inside a building where open flame or sparks are
present. Allow engine to cool before storing.
Never store snowthrower in house (living area)
or basement because gasoline and fumes are
highly flammable, explosive, and dangerous if
inhaled.
All manuals and user guides at all-guides.com
22. Keep all nuts, bolts, and screws tight to ensure
snowthrower is in proper working condition.
23. Perform maintenance and use storage
instructions described in this manual. Reinstall
fuel tank cap if upper shroud is removed for
maintenance.
24. ALWAYS USE GENUINE TORO
REPLACEMENT PARTS AND
ACCESSORIES TO ASSURE SAFETY AND
OPTIMUM PERFORMANCE. NEVER USE
"WILL FIT" REPLACEMENT PARTS AND
ACCESSORIES.

Sound Pressure Level

Model 38181
This unit has an equivalent continuous A-weighted
sound pressure at the operator ear of: 89 dB(A), based
on measurements of identical machines per ANSI
B71.5-1984 procedures.

Sound Power Level

Model 38181
This unit has a sound power level of: 101 dB(A) /
1 pW, based on measurements of identical machines
per procedures outlined in Directive 79/113/EEC and
amendments. The test surface consisted of a surface
of coconut mat surrounded by 2" grass.

Vibration Level

Model 38181
This unit has a maximum vibration level of
11.3 m/s , based on measurement of identical
machines per ISO 5349.
GB–3