Lock And Key; Bottle Holder; Features - AGA MARVEL SCIENTIFIC MS15RA Serie Instructions D'installation, D'utilisation Et D'entretien

MS15RA, MS24RA and SA24RA features
There are three adjustable shelves for flexibility of content
storage. The shelves can move up or down to accommo-
date various content sizes.

Lock and Key

The optional lock and key allow you to lock and store con-
tents.
Content Temperature versus Air Temperature
Air temperature moves up and down with door openings
and compressor run and off cycles. Air has little thermal
mass and therefore changes temperature relatively quickly
between on/off cycles. Stored contents have much higher
thermal mass so their temperatures change much slower.
Always measure temperature with a mass weighted sensor
to determine if the contents being stored are at the proper
temperature.
CAUTION
!
Make sure your cantilever shelf is secure on the shelf sup-
ports by pressing down on the shelf before loading.

Bottle Holder

For your convenience a bracket has been provided to
hold your in-house temperature monitoring bottle. On the
MS24RA it is located on the right side of the interior liner
toward the top.
Figure 12
Bottle holder

FEATURES

Probe Port
The probe port is a hole from the inside to the outside of
the unit, which is located on the back of the unit. (See
Figure 13). Remove the foil label and foam plug(s) from
the hole in the back of the unit, insert your probe or wires
through the hole in the back of the unit. Seal hole with foam
plug(s).
Foil label,
remove to
access probe
port hole.
NOTE: Avoid
blocking fan
with tall objects
as this can
cause freezing
of product and
hinders proper
air flow.
NOTE: To maintain proper air flow in refrigerator, try to
keep product on shelf within the perimeter of shelf.
NOTE: Avoid blocking or
placing product against
CONTROL SENSOR as this will
affect performance of your
refrigerator.
10
-Foam plug(s)
Figure 13
NOTE: For best
performance do
not install top
shelf above this
level or product
may get too cold
on the upper
shelf.
NOTE: If you
are not using
the provided
monitoring bottle
mounting bracket,
either remove
bracket and mount
bottle in this
location or place
bottle in front of
bracket for best
monitoring results.