Settings And Functions - AGA MARVEL MP42SS2 Instructions D'installation, D'utilisation Et D'entretien

Settings and Functions

I n order for your new Marvel Professional refrigerator to work properly, it is important that you understand its various features,
controls, and how to use them.
Power On/Off Switch (Power Interruption Switch)
The power on/off switch is located behind your refrigerator's top grille. It is
used to turn the power off when cleaning the refrigerator. Your refrigerator
arrives from the factory with the power interruption switch on.
To turn power off, remove the center grille blade by lifting outward. Press the
power on/off switch to the off position.
To turn power on, press power on/off switch to the on position. Replace the
center grille blade.
IMPORTANT: Be sure the power on/off switch is in the on position after cleaning or changing light bulbs.
Showroom Mode Initiation
Showroom mode allows electronic controls and interior lights to function independently of refrigeraton system.
To enter the showroom mode: Press and hold "ACTIVATE CONTROLS" pad; while holding, press and hold the "HIGHER"
and "ALARM OFF" pads together for 3 seconds. Three beeps will sound and SHOW will be lit. Showroom mode is entered.
To exit the showroom mode: press and hold "ACTIVATE CONTROLS" pad; while holding, press and hold the "HIGHER" and
"ALARM OFF" pads together. Three beeps will sound and control will revert to normal operation and display.
Electronic Temperature Settings
Your refrigerator's electronic controls are located behind the door above the cabinet interior. To activate the electronic control
panel, press "ACTIVATE CONTROLS" pad. All other pads, except the "ALARM OFF" pad, will remain inactive until the
"ACTIVATE CONTROLS"pad is pressed. Once activated, pad remains programmable for at least ten minutes.
When you fi rst plug your new refrigerator in, you will fi nd that the refrigerator is factory set at 38° F in the refrigerator and 0°
F in the freezer. Wait 24 hours after plug-in for the cabinets to reach this setting. After 24 hours, you may adjust controls as
desired.
To change from °F to °C, press and hold "ACTIVATE CONTROLS" then press and hold "ALARM OFF" for 3 seconds. To
change back, follow the same steps.
To adjust the refrigerator or freezer temperature, simply press the "ACTIVATE CONTROLS" pad, then "Ref Temp" pad or
"Frz Temp" pad. Press the "HIGHER" or "LOWER" pad to adjust temperature setting one degree at a time.
Note: Allow 24 hours for temperature to reach desired setting after any change in set temperature.
Entry Tone
The entry tone is the "beep" you will hear when you press the control pad. You can deactivate the entry tone by pressing
and holding the "ACTIVATE CONTROLS" pad for three to fi ve seconds. You will hear three short beeps to let you know that
the entry tone feature has been deactivated.
To activate the entry tone, simply press and hold the "ACTIVATE
CONTROLS" pad for three to fi ve seconds.
Fast Cool
Fast Cool runs the compressor at high speed for 2 hours to cool the refrigerator as quickly as possible. After 2 hours, the
refrigerator will return to the previous setting.
To activate fast cool, press "ACTIVATE CONTROLS" followed by the "FAST COOL" pad. The fast cool light will be lit.
FREEZER FREEZER REFRIGERATOR REFRIGERATOR
F
C
MAX FRZ MAX REF MAX FRZ MAX REF
FAST COOL FAST COOL
SAB SHOW SAB SHOW
8
DOOR OPEN DOOR OPEN
POWER POWER
HIGH TEMP HIGH TEMP
Power
Switch