Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLING YOUR REFRIGERATOR OR FREEZER
Select Location
The proper location will ensure peak performance of your
appliance. We recommend a location where the unit will
be out of direct sunlight and away from heat sources. To
ensure your product performs to specifications the recom-
mended installation location temperature range is from 55
to 100°F (13 to 38°C).
Cabinet Clearance
Ventilation is required from the bottom front section of the
unit. Keep this area open and clear of any obstructions.
Adjacent cabinets and counter top can be installed around
the unit as long as the grille and door access remain unob-
structed.
WARNING
!
An optional stacking kit is required to stack products.
Failure to use a stacking kit could result in personal
injury. Contact your dealer or Aga Marvel customer
service at 800-223-3900 to order.
CAUTION
!
Front Grille
Do not obstruct the front grill. The openings within the front
grill allow air to flow through the condenser heat exchanger.
Restrictions to this air flow will result in increased energy
usage and loss of cooling capacity. For this reason it is im-
portant this area to not be obstructed and the grill openings
kept clean. AGA MARVEL does not recommend the use of
custom made grills as air flow may be restricted because of
inadequate openings. (See Figure 2).
Figure 2
Leveling Legs
Adjustable legs at the front and rear corners of the appli-
ance should be set so the unit is firmly positioned on the
floor and level from side to side and front to back. The
overall height of your appliance may be adjusted higher (by
turning the leveling leg out, CCW) and lower (by turning the
leveling leg in, CW) dimensions as shown in Table "A".
To adjust the leveling legs, place the appliance on a solid
surface and protect the floor beneath the legs to avoid
scratching the floor. With the assistance of another person,
lean the appliance back to access the front leveling legs.
Raise or lower the legs to the required dimension by turning
the legs. Repeat this process for the rear by tilting the appli-
ance forward using caution. On a level surface check the
appliance for levelness and adjust accordingly.
The front grille screws may be loosened and the grille ad-
justed to the desired height. When adjustment is complete
tighten the two front grille screws. (See Figure 5).
Model
Door Style
MS15RA*
(S)
MS24RA*
(G) or (S)
SA24RA*
(S)
Table A
4
Front Grille,
keep this area
open.
Leveling Legs
Minimum
Maximum
Height
Height
33
⁄
"
34
⁄
"
3
3
4
4
(85.7 cm)
(88.3 cm)
33
⁄
"
34
⁄
"
3
3
4
4
(85.7 cm)
(88.3 cm)
31
"
32
⁄
"
1/
1
8
8
(79.1 cm)
(81.6 cm)
Publicité
Chapitres
Table des Matières
Dépannage
