Dometic WAECO PerfectView M5L Instructions De Montage Et De Service page 34

_M5L_M7L_M7LX.book Seite 34 Donnerstag, 14. Januar 2010 3:03 15
Using the LCD monitor
Page 2:
– Language: "English" or "German"
– Reset ("Default"): Default setting for all parameters
– Camera1/Camera2: "Normal" or "Mirrored"
– M7LX: Camera3: "Normal" or "Mirrored"
– M7LX: Distance: Distance markers (chapter "Setting distance markers
(M7LX) (fig. 0, page 5)" on page 35)
Press the "–" button (4) or "+" button (5) to set the parameter of your choice.
Press the "–" button (4) to reduce the value of the selected parameter.
Press the "+" button (5) to increase the value of the selected parameter.
8.4 Setting the video source (fig. 0, page 5)
NOTE
I
If you have connected the green cable to the reversing light and voltage is
present, reversing camera V1 is activated automatically (see chapter
"Using the monitor with two reversing cameras (trailer operation) (fig. c,
page 6)" on page 35).
M5L, M7L
If you wish to switch to a different video source (from camera 1 to camera 2),
press the "C1/C2" button (1).
The monitor switches from camera 1 to camera 2 or vice-versa.
M7LX
If you would like to switch to a different video source, press the "C1/C2/C3"
button (1).
The monitor changes the camera in the order "camera 1 – camera 2 –
camera 3".
If you wish the cameras to run automatically, press and hold the "C1/C2/C3"
button (1) for at least three seconds.
The monitor display the "AUTO" mode.
The monitor changes the cameras in the order "camera 1 – camera 2 –
camera 3" automatically in the preset time intervals.
No sound is available in this operating mode.
If you wish to set the display time (2 s to 16 s):
Press the "–" button (4) to reduce the camera display time.
Press the "+" button (5) to increase the camera display time.
To end the automatic function, press the "C1/C2/C3" button (1) again.
The monitor displays the "MANUAL" mode.
34
All manuals and user guides at all-guides.com
PerfectView M5L, M7L, M7LX