Dometic WAECO PerfectView M5L Instructions De Montage Et De Service page 32

_M5L_M7L_M7LX.book Seite 32 Donnerstag, 14. Januar 2010 3:03 15
Mounting the LCD monitor
Observe the following instructions when laying the connection cable:
Feed the connection cable through existing ducts or other openings where
possible, e. g. ventilation grilles. If no suitable ducts or openings are available
you will need to drill a hole of ∅ 20 mm. Check beforehand that there is sufficient
space on the other side for the drill head to emerge (fig. 2, page 3).
To prevent damage to the cables, when laying them ensure that there is always
a sufficient interval to vehicle components which can become hot (lights,
heaters, ventilators etc.).
Wrap insulating tape around every connection on the cable (even inside the
vehicle).
When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3, page 3).
Connecting the monitor as a reversing video system (fig. d, page 7)
Lay the connection cable for the monitor bracket on the dashboard.
Insert the plug of the monitor cable (2) into the socket (4) of the connection
cable (3).
NOTICE! Risk of damage
A
Make sure the polarity is correct when connecting to a voltage source.
Connect the red and black cables of the connection cable to a suitable voltage
supply:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
If the monitor is to be activated when reverse gear is selected, connect the green
cable (8) to the positive cable of the reversing light.
NOTE
I
If voltage is present in the green cable (8), the reversing camera will be
activated automatically. The reversing camera has priority.
If the monitor is to be activated e. g. when the indicator is flashing, connect the
following control cable to a positive cable of the indicator:
– M5L, M7L: white cable (8)
– M7LX: white cable (8), blue cable (13)
NOTE
I
If voltage is present in this control cable, the following video input will be
activated:
M5L, M7L: video input C2
M7LX: video input C2, video input C3
32
All manuals and user guides at all-guides.com
PerfectView M5L, M7L, M7LX