LEGRAND Middle Atlantic C5 Serie Mode D'emploi page 13

REAR ANTI-TIP FEET INSTALLATION (C5-FF22-X MODELS ONLY)
NOTE:
• Rear anti-tip feet are pre-installed on 1-bay models.
• Install before wood trim assembly on 2- and 3-bay models.
• Use a 5/16" deep socket and (8x) 10-32 x 3/8" thread forming screws to install both rear anti-tip feet to
the outside locations of your credenza as shown. (FIGURE J)
FIGURE J
LOWERING FRONT AND REAR ANTI-TIP FEET
• Once your credenza assembled and positioned in its final location, lower the front and rear anti-tip feet
(by unscrewing them from brackets) as shown. (FIGURE H)
NOTE: Only attach rear anti-tip
feet to bottom, outside, corner
locations on 2- and 3-bay
models (3-bay shown).
Front Anti-Tip
Foot
Rear Anti-Tip
Foot
FIGURE H
Page 13