Hama T-350 Mode D'emploi page 5

5. Installation
You can either stand the thermometer on an even surface using the fold-out stand
(9) on the back of the device, or attach it to a wall using the opening (8) on the back
of the device.
ote
N
• In order to measure the temperature outside, the outdoor sensor (7) must be
located outside of the building.
• Ensure that the outdoor sensor is protected from direct sunlight and rain.
• Note that the maximum distance between the thermometer and the outdoor
sensor (7) is approximately 150 cm due to the length of the cable. For this
reason, we recommend placing the thermometer near a window or a door.
• Ensure that the outdoor sensor cable is not bent, placed on sharp edges or
otherwise damaged.
arning
W
Before mounting, check that the wall you have chosen is suitable for the weight
to be mounted Also make sure that there are no electric, water, gas or other lines
running through the wall at the mounting site.
6. Operation
• If you do not change the settings, the thermometer is set in the factory to display
the current outdoor and indoor temperature on the display (1/2).
• The thermometer automatically stores the maximum and minimum values for the
outside temperature and inside temperature.
• Press the MAX/MIN button for outdoor temperature (3) / MAX/MIN button
for indoor temperature (5) to display the maximum outdoor temperature/indoor
temperature since the last start/reset.
• Press the MAX/MIN button for outdoor temperature (3) / MAX/MIN button for
indoor temperature (5) again to display the minimum outdoor temperature/indoor
temperature since the last start/reset.
• Press the MAX/MIN button for outdoor temperature (3) / MAX/MIN button for
indoor temperature (5) a third time to display the current outdoor temperature/
indoor temperature.
• Press the RESET button for outdoor temperature (4) / RESET button for indoor
temperature (6) while the maximum or minimum temperature is being displayed in
order to reset the temperature currently shown.
4