Electrical Connection - Gram KF II Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
GB
not become cold enough and there is a
risk of your frozen goods thawing.
You can change over
the door yourself
2
Illustration
shows how easy it is for
you to change the door from right-hinged
to left-hinged, or vice versa.
On models with a tabletop, take off the
tabletop as follows:
Loosen the four screws
screwdriver. The tabletop can now be
drawn out of its frame
can be loosened by removing the two front
screws, this time using a key
ce the cabinet on its back with the front
upwards.
Take off the door handle
the opposite side.
If your refrigerator/freezer has support rails
remove them using a screwdriver.
5
To remove the door, first take out the
screw caps
and then the screws
6
using a key
, as shown in the sketch.
8
Move the hinges
9
and dummy hinges
diagonally (top right hinge to bottom left
corner and bottom right hinge to top left
corner). Move the middle hinge
opposite side and fit screw caps where the
hinge was previously located.
Move the screw cap
12
side of the door and refit the support rails.
When refitting the door, a 9 mm filler
(wood or similar) should be placed be-
tween cabinet front and door edge to crea-
te sufficient space for the sealing strip.
Remember to place the correct number of
washers under the bottom hinge to ensure
that the door is at the correct height.
Once the cabinet has been placed in its
correct position, the hinges may need
readjustment. The elongated holes in the
hinges make this adjustment possible, so
that the sealing strips give optimum sea-
ling all the way round the door.
All manuals and user guides at all-guides.com
using a
1
. The frame itself
2
. Now pla-
3
and move it to
4
7
10
to the
11
to the opposite
Models with freezer drawer
Turn the door handle as described above.
Remove the top hinge and replace it with a
dummy hinge. Now mount the hinge sup-
plied where the dummy hinge was situ-
ated. Remove the middle hinge. Take out
the pin
and spring washer
13
insert them from the other side. Then
mount the hinge in the opposite of the
cabinet and mount the screw cap where
the hinge was situated.
The door can now be mounted as with the
other cabinets.

Electrical connection

Connection to electricity
The cabinet is intended for connection to
alternating current. The connection values
for voltage (V) and frequency (Hz) are
given on the nameplate placed in the cabi-
3
net.
Power must be connected via a wall
socket with a switch. The wall socket
should be easily accessible.
All earthing requirements stipulated by
local electricity authorities must be ob-
served. The cabinet plug and wall socket
should then give correct earthing. If in
doubt, approach your supplier or
authorized electrician.
WARNING - This appliance must be
earthed
The flexible cord fitted to this appliance
has three cores for use with a 3-pin
13-Amp or 3-pin 15-Amp plug. If a B.S.
1363 (13-Amp) fused plug is used, it
should be fitted with a 13-Amp fuse.
IMPORTANT
The wires in this mains lead are coloured
in accordance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
The colours of the wires in the mains lead
, and
14
31

Publicité

Table des Matières
loading

Table des Matières