JUKI MO-6804D Manuel D'utilisation page 68

(2) Adjusting the lift amount of the presser foot
❷
1mm
❸
❻
❺
❹
1) Turn the pulley to lower the feed dog until the bottom of the presser horizontally comes in contact with the
throat plate.
2) Provide a 1-mm clearance between presser foot lifting arm ❶
adjusted by slightly loosening screw ❸.
3) Loosen nut ❹. Press presser foot lifting lever ❻ to lift the presser foot from the throat plate surface. The lift
of the presser foot differs with the model. Adjust the lift of the presser foot according to the model referring
to the table shown below.
Then, adjust screw ❺ so that it comes in contact with presser foot lifting lever ❻. Tighten nut ❹.
4) After all the adjustments above, please tighten the screw ❸.
Model
MO6804D-0E4-30H
MO6814D-BD6-24H
MO6814D-BE6-34H
MO6814D-BE6-24H
MO6814D-BD6-30H
MO6814D-BB6-30P
MO6814D-BE6-30P
MO6814D-BE6-40H
MO6814D-BE6-44H
MO6816D-DE4-30H
MO6816D-DE4-30H-E35
MO6816D-DE4-30P
MO6816D-FF6-50H
中国缝纫机设备网
❶
Lift amount of the presser foot (A)
6
5.5
5.5
5.5
5.5
5
5
7
7
5.5
5.5
5
6.5
– 18 –
(Unit : mm)
www.fengrenjicn.com
❷. This clearance can be