Resetting The Coffee Machine; Cleaning And Care; Regular Cleaning; Cleaning The Height Adjustment - Fagor Espresso CAT 40 NG Notice D'utilisation

GB
14 Resetting the Coffee
Machine
This function is used to reset any
changes you have made to the factory
settings.
The following settings are affected:
• Cup measures
• Coffee quantities
• Coffee temperatures
• Water hardness
Switch the appliance on and wait until
it is in the base position.
Simultaneously press and hold the
"Descale" key (Fig. 3, j)
"Clean" key (Fig. 3, k)
keys pressed for around 3 seconds,
until the coffee machine switches off
for a short time, and then switches
back on with the factory settings. The
coffee machine is now reset.

15 Cleaning and Care

To ensure consistent coffee quality and
faultless operation, always keep your
coffee machine clean.

15.1 Regular Cleaning

Caution! Before cleaning, switch off
the coffee machine and allow it to cool
down. Do not use any abrasive, scour-
ing or corrosive cleaning materials.
Wipe the inside and outside of the case
only with a damp cloth.
Note! Never put the coffee machine or
separate parts of the coffee machine in
the dishwasher.
Note! Never put water in the coffee
bean container, as this would damage
the grinder.
Remove the water tank daily (Fig. 7)
and empty any remaining water away.
Rinse out the water tank with fresh
water. Use fresh water every day.
Empty the coffee grounds container
daily, see „Emptying the Coffee
Grounds Container".
42
All manuals and user guides at all-guides.com
and the
. Keep both

15.2 Cleaning the height adjustment

15.3 Emptying the Coffee Grounds
Regularly drain the drip tray. This can
be done at any time, but must be done
when the red Drip tray float (Fig. 1, I)
appears through the opening in the
drip grille.
Regularly (at least once per week)
clean the Water tank (Fig. 1, M), Drip
tray (Fig. 1, J), Drip grille (Fig. 1, H) and
Coffee grounds container (Fig. 1, G)
with warm water, a mild washing up
liquid and possibly a brush.
From time to time, remove the coffee
bean container and clear away any res-
idues.
Each time the machine is used for
frothing, remove the frothing aid and
clean off any milk remains. The air
intake opening under the seal must not
become blocked. This can be cleaned
out with a thin needle.
If the height adjustment of the coffee
dispenser becomes stiff, remove the
coffee grounds container, open the
service cover and remove it. Slide the
height adjuster right down, and off the
bottom. To do this, gently raise the
inside catch. Use warm water to clean
any coffee residues from both parts.
Reassemble the two parts. To do this,
gently pull up the catch. Check the
ease of movement of the height
adjuster. Refit the service cover and
push the grounds container back in
place.
Container
At regular intervals, after every 16 cof-
fee brews "1 cup" resp. 8 coffee brews
"2 cups", the "Empty grounds con-
tainer" indicator (Fig. 3, h)
that the container has to be emptied
and cleaned.
When the coffee machine is in daily
use, empty the container daily. The
indicator flashes for around 1 minute
each time the machine is switched off,
as a reminder to do this.
signals