Petrol Filter; Changing The Oil, Checking The Oil Level (Before Each Use); Low Oil Switch Off; Preparation For Storage - Parkside PSE 2800 A1 Instructions D'utilisation Et Consignes De Sécurité

Cleaning, maintenance, storage, transport and ordering replacement parts
Petrol filter (Fig. A)
Note: The petrol filter
5
directly under the petrol cap
added.
Turn the ON /O FF switch
position.
Open the petrol cap
2
Remove the petrol filter
flammable solvent or solvent with a high tlash
point.
Reinsert petrol filter
5
Close the petrol cap
Changing the oil, checking the
oil level (before each use)
Changing the oil should take place when the engine
is warm.
Only use engine oil (15 W-40).
Put the generator on a suitable mat, slightly
tilted towards the oil drain plug
Open the oil fill plug
Open the oil drain plug and pour the warm
engine oil into a collection tank.
After pouring out the old engine oil, close the
oil drain plug and put the generator upright.
Pour in engine oil up to the top mark on the
dipstick (approx. 0.6 l).
ATTENTION! When checking the oil level
with the dipstick (oil fill plug) do not screw it
on, just plug it in until the threads.
The old oil must be disposed of according to
the regulations.

Low oil switch off

The low oil switch-off responds, if there is not enough
engine oil. In this case, the engine will not start or
switches off automatically after a short period of
operation. A restart will only be possible after top-
ping-up the oil level (see Chapter "Oil change,
checking the oil level (before every use)").
All manuals and user guides at all-guides.com
is a filter bowl located
, filtering any petrol
2
to the "OFF"
11
.
and clean in a non-
5
.
.
2
.
9
.
8

Preparation for storage

Empty the petrol tank with a petrol suction pump.
Start the engine and leave it running until the
rest of the petrol has been used up.
Change the oil after each season. To do this,
remove the old oil from the warm engine and
refill with new oil.
Remove the spark plug (fig. N). Fill about 20 ml
of oil into the cylinder using an oil can. Slowly
pull the express start so that the oil protects the
cylinder from the inside. Screw the spark plug
back in.
Store the device in a well ventilated place or
area.

Preparation for transporting

Empty the petrol tank with a petrol suction pump
or alternatively using the petrol tap and a suita-
ble canister.
Once it it ready for use, leave the engine running
until the rest of the petrol has been used up.
Empty the engine oil from the engine (as de-
scribed).
Remove the spark plug connector (Fig. M) from
the spark plug.
Secure the device with a tension belt to prevent
it slipping out of place.

Ordering spare parts

When ordering replacement parts you should give
the following information:
Type of device
Device article number
Device ID number
Find current information at
www.kompernass.com
Note: Spare parts not listed (e.g. carbon brushes,
switches) can be ordered through our call centre.
GB 33