Technical Data; Noise Information; Vibration Information; Accessories - Worx WX820 Mode D'emploi

TECHNICAL DATA

Type Designation WX820 WX820.1 WX820.9
(82-designation of machinery, representative of
Multi Sander)
WX820
Charger Volt-
age
Voltage
No-load
speed
Orbital Random orbit-2.5mm, Finish-1.8mm,
diameter
Speed
settings
Machine
weight
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.

NOISE INFORMATION

12
A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection.

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emis-
sion value:
The declared vibration total value and the declared noise
emission value have been measured in accordance with a
standard test method and may be used for comparing one
tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
5-in-1 Multi Sander
WX820.1 WX820.9
100-240V ~ 50/60Hz
20 V Max**
4000-10000 /min
Detail-1.8mm
1-6
2.0kg 1.5kg
L : 77 .6dB(A)
pA
L : 88.6dB(A)
wA
a =3.731m/s
2
h
Uncertainty K = 1.5m/s²
WARNING: The vibration and noise emissions
during actual use of the power tool can differ from the
declared value depending on the ways in which the tool is
used especially what kind of workpiece is processed
dependant on the following examples and other variations
on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use should
also take account of all parts of the operating cycle such as
the times when the tool is switched off and when it is running
idle but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and
keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration
and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.

ACCESSORIES

3 dB(A)
Battery pack
(WA3551.1)
Battery pack
(WA3553)
Charger
(WA3860)
Finishing plate
Random Orbit
plate
Detail plate
Finger plate
Contour plate
Dust bag
Paper punch
WX820 WX820.1 WX820.9
1 1
/ 1
1 1
1 1
1 1
1 1
1 1
1 1
1 1
1 1
/
/
/
1
1
1
1
1
1
1
EN