Program Overview; Tens Program Table - Beurer EM 59 Heat Mode D'emploi

General information
If you wish to return to the previous selection menu, press the
MENU button. By pressing and holding the ENTER button,
you can skip individual setting steps and start directly with the
stimulation treatment.
Keylock
Locks the buttons to avoid them being pressed unintentionally.
1. To activate the keylock, hold down the ENTER button until the
symbol is visible in the display (approx. 3 seconds).
2. To deactivate the keylock, hold down the ENTER button again
until the symbol disappears from the display (approx. 3 se-
conds).
Pausing use
You can pause the stimulation at any time by briefly pressing the
ON/OFF button . To continue the stimulation, briefly press the
ON/OFF button again and set the desired impulse intensity
again.
6. Heat
In addition to the TENS/EMS/Massage programs, the EM59 Heat
also offers two heat levels, which can be activated as required for
all programs, see section 5.2 on usage. The heat emitted by the gel
pads relaxes the muscle and improves circulation. You can activate
the first level of the heat function by pressing the Heat button. Then
wait a moment until the temperature stops increasing. If the tem-
perature is too low for you, you can activate the second level of the
heat function by pressing the Heat button again. If you would like
to deactivate the heat function, you can do so by pressing the Heat
button again
If you want to use the heat function separately, without additional
stimulation, proceed as follows:
Step 1: Position the electrodes in your desired target area. (See
section "7.4 Information regarding the positioning of elect-
rodes" for placement suggestions) and connect them with
the device
Step 2: Press the ON/OFF button to switch on the device
Step 3: Press the Heat button in order to access the Heat settings
˄/˅
Step 4: Use the setting buttons to select the treatment time you
want and press the ENTER button to confirm your selection
Step 5: Press the Heat button again in order to switch on the first
level of the heat function. Then wait a moment until the tem-
perature stops increasing. If the temperature is too low for
you, you can activate the second level of the heat function
by pressing the Heat button again.

7. Program overview

The digital EMS/TENS unit features a total of over 70 programs:
• 15 TENS programs
• 35 EMS programs
• 20 MASSAGE programs
In all programs you can set the impulse intensity of both channels
individually.
You can also set various parameters in TENS programs 13–15
and EMS programs 33–35 to adjust the stimulating effect to the
application area.

7.1 TENS program table

Progr. Practical areas for application, indications
no.
1 Pain in upper limbs 1
2 Pain in upper limbs 2
3 Pain in lower limbs
4 Ankle pain
5 Shoulder pain
6 Pain in the back
7 Pain in bottom and back of thighs
27
Running Possible
time electrode
(min) positions
30 12–17
30 12–17
30 23–27
30 28
30 1–4
30 4–11
30 22, 23