Check Weighing - Uline H-5836 Mode D'emploi

ZERO
If there is a minor weight displayed without anything
on the platform, press the ZERO key
display. Zero indicator will be shown on the display.
TARE
When weighing an item that is in a container, taring
stores the container weight to memory so only the item
weight is displayed.
To store tare weight into memory and set display to zero:
1. Place an empty container on the platform.
2. Press the TARE key
displayed on the bottom of the display.
3. The container's weight is then stored in the scale's
memory and zero is displayed.
4. Add pieces to the container. As the pieces are
added, their net weight will be displayed.
5. Press the G/N key
and net weight.
6. Removing the container from the platform will cause
the scale to display the container's negative weight.
Pressing the TARE key
WEIGHING
Use this mode to weigh items.
1. Place item to be weighed on the scale platform.
Weight will be show in the display.
COUNTING
Use this mode to count parts of uniform weight.
SAMPLE OF UNIT WEIGHT
The scale cannot determine how many pieces are on a
platform without a sample.
1. Place objects intended for sampling on the platform.
2. Press the PCS/SET key
P 10
mode. will be shown on the display.
3. Press the TARE key
quantity – 10, 20, 50, 100 or 200 units.
P 10 / P 20 / P 50 / P 100 / P 200
4. Press the ZERO key
display followed by the sample quantity.
PAGE 6 OF 36
OPERATION CONTINUED
to clear the
. The net indicator will be
to display the gross weight
will readjust the scale to zero.
to enter the counting
to change the sample
----
. " " will be shown on the
5. Place remaining objects on the platform. The total
quantity will be displayed.
6. Press the PCS/SET key
weighing mode.
LACK OF UNIT WEIGHT
The minimum weight must be at least 20 times the scale
accuracy for accurate calculations. Reference the
table below for minimum weights.
Minimum Piece
Model #
H-5836
H-5837
If the unit weight is too light, another scale is needed.
Continuing to use this scale will result in less accurate
results.

CHECK WEIGHING

Use this mode to set a number for a weighing check. When
the weight of the objects on the platform is between the
preset checking numbers, the alarm sound beeps repeatedly.
SET CHECK WEIGHT
NOTE: Weight on platform must be equal to
or greater than minimum weight in order for
check weighing mode to operate accurately.
1. Press and release the UNIT key
PCS/SET key simultaneously.
on the display.
2. To set the high limit, press the ZERO key
00000
will be shown on the display with the last
digit blinking.
3. Key in the high limit. Use the G/N key
ACC/TTL key to move the active digit left and right.
Use the TARE key
4. Press the ZERO key
shown on the display.
5. Press the TARE key
display.
6. To set the low limit, press the ZERO key
will be shown on the display with the last digit blinking.
to exit to the normal
Minimum Sample
Weight Weight
0.01 lb. 0.4 lb.
0.025 lb. 1 lb.
and the
SEt H
will be shown
and the
to increase the numeric value.
Set H
to confirm. will be
et L
until S is shown on the
.
0621 IH-5836
.
00000