REMOVING THE SHIPPING SCREW
1.
Remove shipping screw from bottom of the scale
base using a 2 mm Allen wrench. (See Figure 2)
Scale Base
Shipping
Screw
Figure 2
INSTALLING THE PLATFORM
1.
Remove protective covering from the scale platform.
2. Place the platform on top of the scale base.
CAUTION! Do not press down with excessive
force. This could damage the load cell.
LEVELING
1. The scale is equipped with a level indicator located
on the back of the scale on the base bracket.
Figure 3
(See Figure 3)
2. Use the adjustable leveling feet located on the
bottom of the scale until the bubble appears in the
Figure 4
Not Level
center of the indicator. (See Figure 4)
NOTE: Check the level indicator every time scale is
moved to a new location to verify scale is balanced.
PAGE 2 OF 36
Base
Bracket
Level
Indicator
Adjustable
Leveling Foot
Level Indicator
Level
SETUP CONTINUED
ASSEMBLING THE COLUMN
1.
Unscrew the carriage bolt in the column using a Phillips
screwdriver and detach the support bracket from the
column. Unscrew four small Phillips head bolts from the
support bracket. Set column, support bracket, carriage
bolt and small Phillips head bolts aside.
2. On the base bracket, loosen two set screws using
a 2 mm Allen wrench and the socket cap bolt using
a 4.5 mm Allen wrench. (See Figure 5)
Figure 5
3. Insert column into base bracket. Make sure column
rests on the bottom of the base bracket. (See Figure 6)
Pull display cable all the way through the column so
no slack is under the platform.
4. Secure column with set screws using a 2 mm Allen
Figure 6
wrench and with the socket cap bolt using a 4.5 mm
Allen wrench, but do not tighten.
Display
Cable
Socket Cap Bolt
Display
Cable
Set
Screws
Base
Bracket
Column
Base
Bracket
0621 IH-5836