Safety Notices; Troubleshooting Table - frieling 2SV Mode D'emploi Original

Be careful during re-installation, so that nothing is damaged and the sealing profile is
placed correctly so that the device can work properly.
7 Troubleshooting
The following table may help you narrow down and address minor malfunctions:

7.1 Safety notices

WARNING
Only qualified electricians, who have been trained by the manufacturer may carry out
any repairs on electrical equipment.
Improperly performed repairs may result in personal injury or damage to the device.

7.2 Troubleshooting table

Fault
Device does not turn
on.
A complete vacuum
is not being created
in the bag.
The bag is not being
sealed correctly
The bag does not
hold the vacuum
after it has been
Possible Cause
Plug is not plugged in.
Defective power cord or plug.
Socket is defective.
The open end of the bag is not
completely inside the vacuum
chamber
The bag is defective
There is residue on the sealer
and the seal
The sealing bar is overheating
so that the bag melts
Roll / bag is not positioned
correctly.
The bag is defective
To Rectify
Plug in.
Contact Customer Service
Choose another socket.
Position the bag correctly
Select another bag
Clean the welding / seals and
retry once they are dry
Open the cover on the unit and
let it cool down for a few minutes.
Please use only specified bags
and rolls
Carefully follow all the steps in
Chapter Vacuuming and sealing.
Select another bag, wrap paper
around any sharp edges within
the bag.
16