EN
Installation / Removal
To install/remove the HOME TWO, contact a certified professional (electrician).
Information regarding set-up can be found in the HOME TWO technical documentation,
available at www.greenmotion.ch/common/documentation.
To find a professional electrician, go to
Start / Stop charging
There are two possible operating modes to start/stop charging with the HOME TWO :
Free : charging is controlled directly by the START button on the control unit.
App : charging is secured through a password and controlled by the evpass mobile
application (over Bluetooth).
Free access: start / stop charging
1. Check that the HOME TWO is ready for use. Ensure the START button is showing a solid
green light and not flashing. If not, press the button.
2. Plug the connector into your vehicle.
3. While your vehicle is charging, the HOME TWO START button will flash blue.
4. To stop charging, unplug the connector from your vehicle. Usually, the connector must first
be released from inside your vehicle (see the instruction manual for your vehicle).
The START button on the HOME TWO will show a solid blue light when your vehicle is fully
charged.
5. If you wish to turn off the HOME TWO, press the START button.
evpass application : start / stop charging
To use this option, the HOME TWO charging station must first be configured with the evpass
mobile application. Instructions for this are included in the section "evpass application: setting up
the HOME TWO charging station". If you have chosen the mode "App (button disabled) ", you will
only be able to control your HOME TWO charging station via the application.
1. Plug the connector into your vehicle. Check that the HOME TWO is ready for use and that
the Bluetooth is activated on your smartphone. The START button must be showing a solid
green light and not flashing.
2. To start charging, select:
Menu
> My charging stations
www.greenmotion.ch/Common/Distributors
> HOME TWO charging station > Touch to charge
34