FORS TKE 7650WP Premium Notice D'utilisation page 76

76
Max. loading exceeded.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
Filters not locked in place.
does not close
Err ( Error ) on
Attempt to change parameters after start
5)
of the programme.
the LCD.
Programme selector in OFF position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis of:
elapsing time
type, volume and dampness of laundry.
5)
on the LCD
Programme
Full water reservoir.
inactive
Drying cycle Small laundry volume./Too dry laundry for
to short selected programme.
Fluff filters clogged.
To high loading volume.
Drying cycle
Laundry insufficiently spun.
6)
to long
Particularly high room temperature - no
machine fault.
1) In case of error message on the LCD (e.g. E51 - only dryers with the LCD): Switch the dryer off and
on. Set programme. Press the START PAUSE button. Does not work? - inform local service and quote
the error code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaning chapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Changing the bulb for interior lighting
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local service centre.
Important! When the appliance is switched
on, the interior lighting switches itself off after
4 minutes when the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Before replacing the bulb, disconnect
the mains plug; with a permanent con-
nection: fully unscrew or deactivate the
fuse.
All manuals and user guides at all-guides.com
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course filter
into place.
Turn the dryer off and on. Set requested
parameters.
Turn it to DRUM LIGHT (if available) or to
any programme.
Replace light bulb (see next section).
Automatic process; this is not a machine
fault.
Empty water reservoir
PAUSE button.
Select time programme or higher drying
level (e.g. EXTRA DRY).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
1. Unscrew cover above the bulb (this can
be found directly behind the loading aper-
ture, at the top; refer to "Description of
machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gas-
ket before screwing back the door light cov-
er. Do not operate the dryer when missing o-
ring gasket on door light cover.
Warning! For safety reasons, the cover
must be screwed down tightly. If this is
not done, the dryer must not be
operated.
4)
.
3)
, press START