FORS TKE 7650WP Premium Notice D'utilisation page 65

• The feet must never be removed. Do not
restrict the floor clearance through deep
pile carpets, strips of wood or similar. This
might cause heat built-up which would in-
terfere with the operation of the appliance.
Important!
• The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The ap-
pliance must therefore not be installed on
floors which are not resistant to high tem-
peratures.
• When operating the tumble dryer, the
room temperature must not be lower than
+5°C and higher than +35°C, as it may af-
fect the performance of the appliance.
• Should the appliance be moved, it must be
transported vertically.
• The appliance must not be installed behind
a lockable door, a sliding door a door with
a hinge on the opposite side to that of the
appliance in such a way that a full opening
of the dryer is restricted.
Removing transport safety packaging
Caution! Before use all parts of the
transport packaging must be removed.
1. Open loading door.
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
Warning!
If the appliance was not transported in an
upright position, leave it to stand for 12 hours
before connecting it to the electricity supply
and using it for the first time, so that the oil
can flow back to the compressor. Otherwise
the compressor could be damaged.
All manuals and user guides at all-guides.com
Electrical connection
Details on mains voltage, type of current and
the fuses required should be taken from the
type plate. The type plate is fitted near the
loading aperture (see "Product description"
chapter).
Connect the machine to an earthed
socket, in accordance with current wir-
ing regulations.
Warning! The manufacturer declines
any responsibility for damage or
injury through failure to comply with
the above safety precautions.
Should the appliance power supply
cable need to be replaced, this must
be carried out by our Service Center.
Warning! The plug must be
accessible after installing the
machine.
Door reversal
Warning! Before changing the door
stop, disconnect the mains plug.
A
A
1. Open loading door.
2. Unscrew hinge A from the front of the
machine and take off the loading door.
3. Remove cover plates B . To do this, in-
sert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block C from the
snap-on fixture, take out and re-insert on
the other side having rotated the block
through 180°.
5. Unscrew hinge A from the loading door,
rotate through 180°, re-insert on the op-
posite side and screw down.
6. Re-insert cover plates B on the opposite
site having first rotated them through
180°.
65
B
C
B