FORS TKE 7650WP Premium Notice D'utilisation page 71

Select drying pro-
gramme
Use the programme
selector to set the
programme you re-
quire. The estimated
time to end of the
programme appears
in the LCD (hours:mi-
nutes).
Available options:
Dryness (Trockengrad)
Increases the dryness of the dried laundry
adequately to the selected level:
, . This option helps to achieve
satisfying result of drying.
Spin speed (U/Min.)
Shorten the drying cycle adequately to the
spin speed the laundry was spun previously
in the washing machine. The higher spin
speed was, the shorter drying cycle length.
Available spin speed values (rpm): from
up to (with 200 rpm steps)
This option allows to save time and energy.
Long anti-crease (Knitterschutz)
Prolongs standard anti-crease phase at the
end of the drying cycle to 90 min. When ac-
tive the symbol is on. This option helps to
keep laundry free from creases. Laundry can
be removed at any time during the anti-
crease phase.
Buzzer (Signal)
Audible confirmation of:
All manuals and user guides at all-guides.com
Set drying option
Select one or more
options. Press ap-
propriate option but-
ton. Some options
might be not availa-
ble with some drying
programmes (see
Programme chart
chapter)
,
Start the pro-
gramme
Press the Start
Pause button. The
programme starts.
– cycle end
– anti-crease phase start and end
– cycle interruption
– error
When active the symbol
Time (Zeitwahl)
Operates only with Time programme (Zeit-
programm). Allows to set individual time of
drying from minimum 10 min. to maximum of
3 hours (in 10 min. steps).
1. Turn the programme knob to the Time
programme (Zeitprogramm).
2. Press the Time (Zeitwahl) button repeat-
edly until the desired programme dura-
tion is shown in the display, e.g.
a programme of 1 hour and 20 minutes.
Delay start (Zeitvorwahl)
Allows to delay the start of a drying pro-
gramme from minimum of 30 min. to
maximum of 20 hours.
1. Select the drying programme and addi-
tional options.
2. Press the Delay start (Zeitvorwahl) button
repeatedly until the desired delay start is
Programme pro-
gress
Time elapses in LCD
(in 1 min. step). Dry-
ing phase is marked
by flashing dash un-
der phase symbol.
Stops flashing when
appropriate drying
phase is finished.
(See Control panel -
Display description
chapter)
is on.
for
71