Beurer BM 55 Mode D'emploi page 18

• Systolic pressdiastolic pressure and
pulse measurements are displayed.
• A symbol at the bottom of the display
also lights up to indicate whether you
were sufficiently relaxed during the
blood pressure measurement (green
symbol = sufficiently at rest; red sym-
bol = not at rest).
• Observe the chapter on interpreting
results/measuring the resting indicator
in these instructions for use.
• appears if the measurement could
not be performed properly. Observe
the chapter on error messages/trou-
bleshooting in these instructions for
use and repeat the measurement.
• Now select the desired user memory by pressing
the M1 or M2 memory buttons. If you do not select
a user memory, the measurement is stored in the
most recently used user memory. The relevant
symbol or appears on the display.
• Using the START/STOP button
8:32 10/29
blood pressure monitor. The measurement is then
stored in the selected user memory.
• If you forget to turn off the device, it will switch off
automatically after approx. 3 minutes. In this case
too, the value is stored in the selected or most
recently used user memory.
• Wait at least 5 minutes before taking
another measurement!
18
, switch off the