ShelterLogic 27274 Guide D'assemblage page 8

step 9
A.
Assure that the cover is positioned so that the valance has even overhang, front to back and side to side.
B.
Slide the pocket pipes into the cover pockets between the cutouts. Attach the pocket pipes to the frame using the 3
& 4 way clamps (800220 & 800221) and the #11130 (2
spaced on both sides of the top pipe. Slide the pocket pipe down the length of the rafters to tighten the top section of
the cover. When the cover is pulled tight secure the bolts and nuts in the sliding clamps to hold them in place.
B
800220
11130
800226
00690
End Rib
C.
Slide the rope through the grommets and around the
side extension tubes at both sides shown.
D.
Insert the 'S' hook to the corner leg tube, then twist
the leg to tighten the rope. After tightening the ropes,
secure the 4 corner legs to the corner connectors and
feet plates with #800218 (3 in.) Bolts and nuts.
step 10
Use the 4 Ratchets (10040) to tighten down the
corners of the cover.
Thread the webbing through the ratchets to pull the
cover snug but not tight.
Make final adjustments to cover rails and clamps
(Step 9). When all of the half clamps and rope are
secured tight finish tightening the Ratchets to make
final adjustment to the cover.
1
/ in.) bolts and nuts. Check that the pocket pipes are evenly
4
A
Fig. 9
Page 8
Middle
Rib
800226
00690
C
Fig. 10
B
800221
11130
800226
00690
D
05_27274_0B