Technical Data - Bosch GSR 10,8 V-LI PROFESSIONAL Instructions D'emploi

All manuals and user guides at all-guides.com
OBJ_BUCH-195-002.book Page 8 Wednesday, September 27, 2006 12:45 PM
Product Features
The numbering of the product features refers to the
illustration of the power tool on the graphics page.
1 Screwdriver bit*
2 Tool holder
3 Locking sleeve
4 Torque presetting ring
5 Soft grip
6 Rotational direction switch
7 On/Off switch
8 Battery release button
9 Battery*
10 "Power Light"
11 Hanging hook*
12 Craftsman case*
13 Carrying holster for cordless screwdriver*
*The accessories illustrated or described are not
included as standard delivery.

Technical Data

Cordless Screwdriver
Article number
Rated voltage V=
No-load speed rpm
Max. torque for hard/soft
screwdriving application
according to ISO 5393 Nm
Max. screw dia. mm
Weight according to
EPTA-Procedure 01/2003 kg
Please observe the article number on the type plate of your
power tool. The trade names of individual tools may vary.
Assembly
Battery Charging (see figure A)
Use only the battery chargers listed on the
accessories page. Only these battery chargers
are matched to the lithium ion battery of your power
tool.
The lithium ion battery is protected against deep dis-
charging by the "Electronic Cell Protection (ECP)".
When the battery is empty, the machine is switched off
by means of a protective circuit: The inserted tool no
longer rotates.
8 | English
WARNING
has been automatically switched off. The battery
can be damaged.
The battery is supplied partially charged. Completely
charge the battery before using your power tool for the
first time. The lithium ion battery can be charged at any
time without reducing its service life. Interrupting the
charging procedure does not damage the battery.
To remove the battery 9, press the unlocking buttons 8
and pull out the battery downwards. Do not exert any
force.
The battery is equipped with an NTC temperature con-
trol which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery ser-
vice life is achieved in this manner.
Observe the notes for disposal.
Changing the Tool (see figure B)
Before any work on the power tool (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the center position.
Unintentional actuation of the On/Off switch can
GSR 10,8 V-LI
lead to injuries.
PROFESSIONAL
3 601 J92 U..
Inserting
10.8
Briefly pull the locking sleeve 3 forwards and then push
0–400 the insert tool to the stop into the tool holder 2. The
insert tool is automatically locked when it is applied to
the screw or the workpiece.
18/7
Removing
6
Pull the locking sleeve 3 forward and remove the insert
tool.
0.8
Operation
Starting Operation
Inserting the Battery
Use only original Bosch lithium ion batteries
with the voltage listed on the nameplate of
your power tool. Using other batteries can lead to
injuries and pose a fire hazard.
Note: Use of batteries not suitable for the machine can
lead to malfunctions of or cause damage to the power
tool.
Set the rotational direction switch 6 to the center posi-
tion in order to avoid unintentional starting. Insert the
charged battery 9 into the handle so that it can be felt
to engage and faces flush against the handle.
Do not continue to press the
On/Off switch after the machine
2 609 932 477 • 27.9.06