White&Brown MAMBO DB 716 Mode D'emploi page 28

All manuals and user guides at all-guides.com
notice_DB716 25/04/06 12:28 Page 28
Fig. 3
• Before the product commissioning, remove
the red plastic cap from the boiler filling hole
and screw the safety cap [11].
Fig. 4
• For the topping up operate as follows:
• Fill the bottle with water.
• Unscrew the safety cap from the filler. If the
steam station was working, open the safety cap
[11] of 1 / 2 turn paying attention, to come out the
steam slowly and then unscrew it completely.
• Pour about 1 litre of water into the boiler.
Place the water filled bottle into the boiler filler
vertically by laying it and do not press.
Then, press down softly to let the water comes
out from the cap. When there are no more air
bubbles the boiler is full.
Avoid filling the boiler too much (1 litre maxi-
mum). If you fill it too much it could be possible
that water comes out (instead of steam) from the
smoothing iron plate.
• Screw the safety cap to avoid any uncontrolled
steam leak.
It is possible to use both cold and hot water from
the tap.
To improve the life of your steam station we
suggest you to always use demineralised water.
The tap water contains a lot of limestone so it is
necessary to use demineralised water.
If you do not know the water degree of hardness
of your home, call your aqueduct department.
Do not use chemical substances or scale
preventers or ironing water residuals in addition
of water. This could damage the ironing station
and the smoothing iron.
28