NuVinci Nfinity 330 Mode D'emploi page 19

8. While driving the CVP clockwise with
the Sprocket (A), rotate the Nfinity Hub
Interface (B) counter-clockwise toward the
full overdrive "H" position until a firm stop
is felt. Repeat this rotation 2-3 times by
driving the CVP clockwise and rotating
the Nfinity Hub Interface back and forth,
ending at a firm stop toward (but likely not
at) the full overdrive "H" position.
•
The indicated position of the Nfinity Hub
Interface is unimportant in this step.
•
When in full overdrive, the hub/wheel
should rotate approximately 1.6-2 times
for every 1 rotation of the CVP sprocket.
09. When full overdrive is found, remove the
Nfinity Hub Interface per step 4. in this
section.
10. Check to make sure the mark on the Spline
nut and shift driver align per step 5. in this
section.
11. Install the Nfinity Hub Interface per section
3.3 and section 3.4.
 At all times while rotating the wheel,
!
sprocket, or Nfinity Hub Interface,
be careful not to catch or pinch
fingers.
TECHNICAL OWNER MANUAL
B
A
NFINITY SERVICE INSTRUCTIONS
EN
19