Renkforce CR-1035 Mode D'emploi page 88

All manuals and user guides at all-guides.com
o) "SETTING" function
• Press the "MENU" button (9) to display the main menu.
• Select the "SETTING" function by turning the control wheel (2) and press the "SNOOZE"
button (3) to confirm.
• Use the control wheel (2) to select the desired function and press the "SNOOZE" button (3)
to confirm.
• Press the "" button (1) to go back to the previous menu.
The following options are available:
"DISPLAY SETTING"
After selecting "DISPLAY SETTING" using the control wheel (2), press the "SNOOZE" button
(3). A menu with the following functions comes up:
"SCREEN SAVER"
You can specify a time after which the display will be switched off (e.g. when the clock radio
is used in the bedroom). You can set 5, 10, 15, 20, or 30 seconds. Press any button to
reactivate the display for the set time.
IF "ALWAYS ON" is enabled, the display is activated permanently.
"BRIGHTNESS"
Here you can adjust the brightness of the display as desired.
"POWER SAVE MODE"
This setting is only active when a time of 5, 10, 15, 20, or 30 seconds has been specified for
the screensaver (see above) ("ALWAYS ON" must not be activated).
"SCREEN OFF" causes the display to be switched off after the time set for the screensaver
has elapsed.
"PENUMBRA" dims the display after the time set for the screensaver has elapsed.
73