Makita EM403MP Manuel D'instructions page 12

Lubricating moving parts
NOTICE:
Follow the instruction of the
frequency and amount of grease supplied.
Otherwise insufficient lubrication may damage
moving parts.
Gear case:
CAUTION:
Do not apply grease when
the gear case is hot. Hot gear case can cause
burn injury.
Apply grease (Shell Alvania 2 or equivalent) to
the gear case through the grease hole every
around 30 working hours.
1
► 1. Grease hole
Drive axle:
Apply grease (Shell Alvania 2 or equivalent) to
the gear case through the grease hole every
around 30 working hours.
NOTE: Genuine Makita grease may be pur-
chased from your local Makita dealer.
Replacing the nylon cord
WARNING:
nylon cutting head, make sure that the
cover of the nylon cutting head is secured
to the housing properly as described below.
Failure to properly secure the cover may cause
the nylon cutting head to fly apart resulting in
serious personal injury.
The way to replace the nylon cord varies
depending on the cutting tool type. Replace the
nylon cord if the cord is not fed any more.
12 ENGLISH
For the bump and feed type