Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Converting the joysticks
Converting the joysticks
1.
Loosen the four screws holding each of the two
joysticks
2.
Then disconnect the 7 pin plug connector from the
joysticks to the circuit boards.
3.
The joystick circuit boards can now be exchanged.
4.
Reconnect each of the 7 pin plugs to the circuit
board
5.
Reassembly is done in reverse order
Ensure that the axis of the joystick circuit board is proper-
ly positioned in the base.
38
Operating notices
2.
3.
Important notices:
When closing the transmitter housing, ensure that ...
•
... no cables are caught between housing edges
when the backplate is put into position
•
... both housing parts are properly aligned with each
another before screwing them together never force
the housing sections together
•
... screws are tightened carefully to avoid stripping the
existing threads in the housing
•
the transmitter battery is finally reconnected
1.
Publicité
Chapitres
Table des Matières
