GRAUPNER SJ HOTT mxs-8 Manuel De Programmation page 37

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Opening the transmitter housing to change the mode
Carefully read the notices below before opening the
transmitter housing. We recommend that unexperienced
users request a Graupner Service location to take care of
the procedures described below.
Attention:
Switch off the transmitter before opening the
housing (press power key at least 2 seconds).
Open the battery compartment and remove the
battery holder as described above.
Then loosen the six countersunk screws on the rear of
the transmitter with a PH1 Phillips screwdriver (refer to
figure above).
Hold the two housing sections together by hand then turn
the transmitter upright over a suitable surface to allow the
six screws to drop out. Now carefully lift the backplate and
fold it open to the right as you would open a book.
Housing screw locations
WARNING:
• Make no modifications of any kind to the
circuitry as this will void the guarantee as well as
the type approval.
• Be sure not to touch the circuit boards with
any metallic objects. Do not touch contacts with
your fingers.
• Never switch the transmitter on when its
housing is open.
Operating notices
37

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hott mxs-123320033201

Table des Matières