Bosch BSG 8 Serie Notice D'utilisation page 18

Fold out picture pages.
Setting up
1
Figure
a) Insert the flexible hose adapter into the air intake open-
ing and allow it to engage.
b) To remove the flexible hose, press the two lugs together
and pull the tube out.
2*
Figure
a) Align and connect the handle and the telescopic tube.
b) Push the handle straight into the telescopic tube until it
engages.
To release the connection, squeeze the collar sleeve and
pull the handle out.
3*
Figure
Attach the carpet lifter to the nozzle.
Press the carpet lifter sideways to engage.
4*
Figure
a) Align and connect the floor tool and the telescopic tube.
b) Push the telescopic tube straight into the connecting
piece of the floor tool until it engages.
Press on the locking collar and pull out the telescopic
tube to disconnect.
5*
Figure
Press the adjusting sleeve in the direction of the arrow
and adjust the telescopic tube to the length required.
6
Figure
Holding the power cord by the plug, pull out the required
length and plug the plug into the mains socket.
7
Figure
To switch your vacuum cleaner on and off, press the
ON/OFF button in the direction of the arrow.
12
All manuals and user guides at all-guides.com
Vacuuming
You have bought an extremely powerful device.
The highest suction setting is therefore only recommended
for heavily soiled, short-pile carpets and hard floors.
Figure
a) For vacuuming rugs and carpets
b) For vacuuming hard floors
Floor tool with carpet lifter*
Figure
Vacuuming with accessories
Figure
Pull the combination tool in the direction of the arrow to
remove it from the tool holder.
a) Crevice nozzle
b) Upholstery nozzle
c) Hard furnishings brush
Before replacing the combination tool in the tool holder,
retract the brush ring and fold the upholstery nozzle
back.
Figure
!
8
Adjusting the floor tool:
9*
When you pull the floor tool backwards, the rug is lifted,
allowing you to clean underneath its edge.
10
For vacuuming in crevices and corners.
For difficult to reach places, the combination tool can be
extended to two different lengths by pulling out the
crevice nozzle.
For either length extension, pull the crevice nozzle out
until you hear it engage.
The crevice nozzle can be pushed back in again by
releasing the telescopic locking mechanism (pressing
it in the direction of the arrow).
For cleaning upholstered furniture,
curtains, etc.
For window frames, cabinets, profiles etc.
Fold the upholstery nozzle over in the direction of the
arrow.
To extend the brush ring, turn in the direction of the
arrow.
11
Secure the drill dust nozzle to the handle and then place
against the wall, so that the nozzle drill hole opening sits
directly over the hole to be drilled.
Select the lowest power setting and then switch on the
vacuum cleaner.
Suction holds the drill dust nozzle in the required posi-
tion.
Depending on the surface of the wall to be drilled it may
be necessary to readjust the power to a higher setting to
ensure the drill dust nozzle is firmly attached.
Any fine particles are automatically vacuumed up.
Caution: the drill dust nozzle should only be used in
conjunction with the dust container since fine drill
dust can impair the function of the dust bag.
en
=>
=>