Intended Use; Safety Information; Disposal Information - Bosch BSG 8 Serie Notice D'utilisation

Masquer les pouces Voir aussi pour BSG 8 Serie:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
Please keep this instruction manual. When passing the
vacuum cleaner on to a third party, please also pass on
this instruction manual.

Intended use

This vacuum cleaner is intended for domestic use only, not
for commercial use.
Only use this vacuum cleaner in accordance with the
instructions in this instruction manual.
The manufacturer will not accept any responsibility for
damage caused by improper use or incorrect operation.
Therefore, please note the following points.
The vacuum cleaner must only be operated with:
Manufacturer's original MEGAfilt
Manufacturer's original replacement parts, accessories
and optional accessories
The vacuum cleaner is not to be used for:
vacuuming persons or animals
vacuuming up:
– Insects and spiders
– Hazardous, sharp-edged, hot or burning substances.
– Damp or liquid substances
– Highly flammable or explosive substances and gases
– Ash, soot from tiled stoves and central heating sys-
tems

Safety information

This vacuum cleaner complies with the recognised rules of
technology and the relevant safety regulations.
We confirm that it complies with the following European
directives: 89/336/EEC (amended by Directives
91/263/EEC, 92/31/EEC and 93/68/EEC), 73/23/EEC
(amended by Directive 93/68/EEC).
Always observe the information on the rating plate when
using the vacuum cleaner and connecting to the power
supply.
Never use the vacuum cleaner without the dust contain-
er or MEGAfilt
SuperTEX dust bags.
®
=> This can damage the vacuum cleaner.
Only allow children to use the vacuum cleaner under
supervision.
Keep the vacuum cleaner away from the face when
using nozzles and tubes.
=> There is a risk of injury.
Never carry the vacuum cleaner by the power cord.
Fully extend the power cord when using the vacuum
cleaner continuously for several hours.
When disconnecting the appliance from the mains, pull
the plug, not the power cord.
Do not pull the power cord around sharp corners or
allow it to become trapped.
Unplug the power cord from the mains before carrying
out any work on the vacuum cleaner or its accessories.
All manuals and user guides at all-guides.com
SuperTEX dust bags
®
Do not use the vacuum cleaner if it is damaged. Unplug
the power cord from the mains if a fault is detected.
For safety reasons, only authorised after-sales service
personnel are permitted to carry out repairs and fit
replacement parts to the vacuum cleaner.
The vacuum cleaner should be protected from moisture
and sources of heat.
Switch off the vacuum cleaner when it is not in use.
At the end of its life, the vacuum cleaner should be dis-
posed of in an appropriate manner.
For safety, the vacuum cleaner is fitted with a tempera-
ture safety switch which automatically switches the vac-
uum cleaner off if it is blocked and overheating. Unplug
the vacuum cleaner from the mains and make sure that
the nozzles, suction pipe and hose are not blocked and
check whether the filter needs replacing.
Having cleared the blockage, leave the vacuum cleaner
to cool down for at least one hour. It can then be
switched back on again.

Disposal information

Packaging
The packaging is designed to protect the vacuum clean-
er from being damaged during transport.
It is made of environment-friendly materials and can be
recycled.
Dispose of packaging that is no longer required at an
appropriate recycling point.
Used vacuum cleaners
Used vacuum cleaners still contain many recyclable
materials.
Therefore, please take used vacuum cleaners to your
retailer or recycling centre so that they can be recycled.
For current disposal methods, please enquire at your
appliance dealership or local council.
!
Please note
Only connect the appliance to a socket rated for at least
16 amps.
If a fuse is tripped when you switch on the vacuum
cleaner, this may be because other electrical appliances
which have a high current draw are connected to the
same power circuit.
To prevent the fuse from tripping, select the lowest
power setting before switching the vacuum cleaner on,
and increase the power only once it is running.
en
11

Publicité

Table des Matières
loading

Table des Matières