DJ-Tech DDM-3000 Guide De L'utilisateur page 7

QUICK SETUP DIAGRAM
Study this setup diagram. Make sure all faders are at "zero" and all devices are off. First, connect all input
sources and processors. Next, connect your microphone and monitor headphones. Finally, connect the
stereo outputs to the power amplifier(s) and/or audio receivers such as tape decks. Plug your mixer into AC
power. Now you are ready to switch everything on.
IMPORTANT: Always switch on your audio input sources such as turntables or CD players first, then your
mixer, and finally any amplifiers. When turning off, always reverse this operation by turning off amplifiers,
then your mixer, and then input devices.
SPECIFICATIONS
Power source
Fuse
Power consumption
Input sensitivity
Input impedance
Output voltage
Output impedance
Frequency response
THD
S/N ratio
Channel separation
Talkover
Dimensions
Weight
All manuals and user guides at all-guides.com
AC 230V~50Hz / AC 120V~ 60Hz
T1AL/250V / T1AL/125V (5x20mm)
0W/ 28 W (off/ max)
1,58V LINE
14,5mV DJ MIC
15,9mV MIC CH1
16,7mV PHONO
5kohms LINE
52.4kohms DJ MIC
10.4kohms MIC CH1
45.6kohms PHONO
6,6V RMS @ 10kohms
550 ohms
20Hz – 20kHz (-1.5dB)
<0.07%
>77dB
>65dB
-15dB
320 (H) x 355 (W) x 110 (D) mm (Rack mount depth 85mm)
4.4kg
7