Double Action - X-lite X-1004 Sécurité Et Instructions D'utilisation

WARNING
- Make sure that the mechanisms are working properly. Open the visor; while lifting the chin guard, the visor
should automatically close. If necessary, repeat the above-mentioned steps.
- Make sure that the mechanisms are working properly. Open and close the visor, making sure that the
mechanisms hold it in the different positions. If necessary, repeat the above-mentioned steps.
- Do not use the helmet if the visor has not been assembled properly.
- Do not remove the side mechanisms from the chin guard.
- Should any of the side mechanisms fail or be damaged, please refer to an X-Lite authorized dealer.

DOUBLE ACTION

In the neutral (central) position, as illustrated in Fig.7A, the DOUBLE ACTION device has no effect on the normal
opening and closing functions of the visor.
The following additional functions are obtained using the corresponding button.
Defogging Function
While wearing the helmet, open the visor onto the first notch and press the button as shown in Fig.7B. Now close
the visor.
In this position, the mechanism keeps the visor open to a minimum to improve the circulation of air and facilitate
defogging, especially at low speeds or during short stops.
Press the button as shown in Fig.7C bringing it back to the neutral position, to deactivate the defogging function.
Visor-Lock Function
While wearing the helmet, close the visor and press the button as shown in Fig.7C.
In this position, the closing mechanism on the visor is strengthened so that the likelihood of it accidentally opening
will be reduced.
Press the button as shown in Fig.7B bringing it back to the neutral position, to deactivate the visor-lock function.
WARNING
- When using the helmet, it is recommended that you limit your use of the visor-lock function, since unexpected
events may require you to open your visor immediately.
- In the event of an emergency, the visor-lock function may be disabled by lifting the visor as normal, and
pressing slightly harder than usual on the visor flap.
WARNING
- Make sure that the mechanisms are working properly. Open the visor; while lifting the chin guard, the visor
should automatically close. If necessary, repeat the above-mentioned steps.
- Make sure that the mechanisms are working properly. Open and close the visor, making sure that the
mechanisms hold it in the different positions. If necessary, repeat the above-mentioned steps.
- Do not use the helmet if the visor has not been assembled properly.
- Do not remove the side mechanisms from the chin guard.
- Should any of the side mechanisms fail or be damaged, please refer to an X-Lite authorized dealer.
DOUBLE ACTION
In the neutral (central) position, as illustrated in Fig.7A, the DOUBLE ACTION device has no effect on the normal
opening and closing functions of the visor.
The following additional functions are obtained using the corresponding button.
Defogging Function
While wearing the helmet, open the visor onto the first notch and press the button as shown in Fig.7B. Now close
the visor.
In this position, the mechanism keeps the visor open to a minimum to improve the circulation of air and facilitate
defogging, especially at low speeds or during short stops.
Press the button as shown in Fig.7C bringing it back to the neutral position, to deactivate the defogging function.
Visor-Lock Function
While wearing the helmet, close the visor and press the button as shown in Fig.7C.
In this position, the closing mechanism on the visor is strengthened so that the likelihood of it accidentally opening
will be reduced.
Press the button as shown in Fig.7B bringing it back to the neutral position, to deactivate the visor-lock function.
WARNING
- When using the helmet, it is recommended that you limit your use of the visor-lock function, since unexpected
events may require you to open your visor immediately.
- In the event of an emergency, the visor-lock function may be disabled by lifting the visor as normal, and
pressing slightly harder than usual on the visor flap.